Effortless force generation up to 80 kN  (8 tons imp) 

• Integrated hydraulic cylinder and pump - no separate pump is required
• Safety valve prevents overloading the spindle and the puller it is used with in case excessive force is applied
• The spring-loaded centre point allows easy centring of the puller on the shaft without damaging it

Effortless force generation up to 50 kN 

• Integrated hydraulic cylinder and pump - no separate pump is required
• Safety valve prevents overloading the spindle and the puller it is used with in case excessive force is applied
• The spring-loaded centre point allows easy centring of the puller on the shaft without damaging it

Efficient and correct dismounting

• The unique design of the TMMS series allows the application of force on most efficient point; the inner ring, and thereby requiring less force for dismounting than when pulling on the outer ring
• The firm grip behind the bearing's inner ring ensures that the pulling forces are only transmitted through the inner ring and not through the outer ring or the rolling elements, preventing bearing damage
• The tri-section construction allows even force distribution, preventing bearing locking and/or tilting on the shaft, especially in the case of SRB and CARBŪ, during dismounting
• Suitable for use in combination with any three-armed puller
• Special wig shape allows the plates to be easily inserted between bearing and the shoulder on the shaft
• Available in a wide range, covering most common shaft sizes

For safety during dismounting

• Offers additional protection for the user during dismounting jobs
• The tough, transparent plastic allows the user to monitor the component and the puller during operation
• Suitable for use in combination with many pullers
• Especially designed to fit TMMA series