With the Easy-Laser D200 BTA Digital, it is easy to document sheave/pulley alignment

• Make a printout, store data in the display unit or transfer data to a PC
• Shows the parallel and angular misalignment of the sheaves, both digitally and graphically in real time
• Calculates both shim- and adjustment values
• Documentation to printer or PC via RS232-interface
• Up to 1000 measurements can be stored
• Much faster and more accurate than measuring with other, conventional methods
• For both horizontal and vertical mounted machines
• Magnetic attachment means that the alignment can be made by one operator

Download Data Sheet

Maintenance are savings

In the industry of today, preventive and predictive maintenance is a matter of course. When aligning with the Easy-Laser® BTA you reduce the wear on sheaves, belts, bearings and sealings and reduce vibrations. This will give you less downtime, which of course means that you increase the available machine time. Time that guarantees your income. Increased efficiency also means large energy cost savings.

Document the result

For years the possibility to document the result of an alignment of e.g. a pump and a motor has been standard. With the Easy-Laser® BTA digital there now is the possibility also to document the alignment of a belt transmission alignment, which stands up to the demands one can have of a modern measurement system.

Easy for the user

The tool is attached in a few seconds, and you are lead step-by-step on the screen through the alignment procedure. The adjustment of the machine are displayed in live on the screen with values for angular and axial offset in both longitudinal (X) and transversal (Y) direction plus adjustment values for rear or front feet. The result is a fast, precise alignment. After finished measurement you can easily store, print or transfer the measurement data to a PC.

New possibilities

With our new SpinLaser Technology™ using rotating laser a whole new world of possibilities for the measurement and alignment work are made available. E.g. the Easy-Laser® BTA digital can also be used for dynamic measurements, parallel measurements of planes and shafts etc. The system reads two or more detectors at the same time "live", which gives you a direct feedback of your work. This will result in a faster and easier alignment than before.

Step-by-step on the screen

1. Enter which machine is the adjustable (M)

2. Enter the distance between the feet

3. Enter the face width for the M-sheave and the S-sheave.
     -The system now automatically compensates for the difference.

4. Place the detector unit vertically according to the display.
     -Record the value

5. Place the detector unit horizontally according to the display.
     -Record the value

6. The display now shows in live the measurement and adjust-/shim values in both vertical and horizontal direction, which makes the alignment really easy. You can now store, print or transfer the measurement data to a PC.