• Fast controllable heating process.
• Safe heating process; only the work piece is heated.
• Elimination of hot oil bath, no risk of localized overheating.
• Suitable for sealed and shielded bearings.
• Suitable for pre-greased bearings.
• Suitable for bearings with polyamide cages.

Technical advantages of TM Easy therm induction heaters:

• Manufactured according to the CE Regulations.
• Fast heating process through high output; Cos phi > 0.8.
• The heating coil is placed horizontal under the part;
  • By this it is impossible to damage the coil
  • This ensures an equal temperature all over the part (inner- and outer ring).
  • This makes it able to heat up parts with smaller bores.
• All heaters are continuously useable without any optional cooling system.
• Constantly monitoring heating process by probe and microprocessor.
• Temperature control accuracy +/- 2°C.
• Timer accuracy 0.01 sec.
• Maintenance free.
• Three years warranty.
• Easy to use; user friendly design.
• Ergonomic design (pivoting yoke principle).
• Automatic power regulation, no manual pre-setting necessary.
• Less than 2A/cm residual magnetism.

Download Data Sheet

• Voltage: 110-240V
• Frequency: 50/60Hz
• Power: 3.5 kVA
• Max. Temp.: 240/400°C
• Weight of heater: 17kG 
• Dimensions heater (lxbxh): 345x200x240
• Induction yokes(mm): 14 x 25 x 40 (Included)
• Max.diameter of work piece: 280mm
• Max. width of Work piece 120mm
• Max.weight of Work piece: up to 40kg (depending on yoke)