The SDT A-weighted sound pressure measurement microphone is to be used in combination with the SDT 170 M and SDT 170 MD Multifunction Ultrasonic Detectors. Sensor dBA SDT 170 with foam wind guard.

This "Digital Thermocouple Interface" allows any ‘J’ or ‘K’-type thermocouple to be connected via this interface with the SDT 170M and SDT 170MD Multifunction Ultrasonic Detectors. The temperature can be read in degrees Celsius or Fahrenheit.

The Inspacto 500 non-contact temperature gun interfaces directly to SDT170M/M+/MD to measure surface temperature by means of infrared energy. Direct connect and interface to SDT 170 display and collector no new firmware required for SDT 170 Version 1.4/Build 5. Temperature gun can be used by itself, or with SDT 170.

Use the SDT Tachometer in either contact or laser non-contact mode to pick up shaft speeds. Log RPM directly to DataManager via the 170MD data collector.

Plug this low flow mass air flow sensor and measure SCFM or SCCM with the Ultrawave 170M or 170MD. Use the flow sensor to guesstimate how much air is escaping from compressed leaks. Cost justify your air leak survey by adding up the total leakage found.