Effortless force generation up to 80 kN

The SKF advanced hydraulic spindle TMHS 8E effortlessly generates maximum force of 80 kN (8 tones imperial), facilitating the easy removal of bearings or other components. The spindle is equipped with an integrated hydraulic pump for force generation. The TMHS 8E is supplied with a nosepiece and three extension pieces, allowing easy and quick adaptation to the shaft's length.

• Integrated hydraulic cylinder and pump - no separate pump is required
• Safety valve prevents overloading the spindle and the puller it is used with in case excessive force is applied
• The spring-loaded centre point allows easy centring of the puller on the shaft without damaging it

Features:

• Generates a maximum withdrawal force of 80 kN (8 tons imp) and has a long stroke of 80 mm (3.1 in), which facilitates dismounting in one operation
• Suitable for use with SKF pullers TMMA 8, TMHP 8, TMBS 100, TMBS 150 and TMHC 108
• Suitable for use with any 8 tonnes puller equipped with a UN 1˝" x 16 tpi threading
• Extension pieces for maximum reach of 350 mm (13.8 in) allow quick adaptation to pulling length

Technical data:

• TMHS 8E
  • Contents
    • 1 x hydraulic spindle
    • 3 x extension pieces;
    • 50, 100 and 150 mm (2.0, 3.9 and 5.9 in)
    • 1 x nosepiece
  • Maximum stroke: 80 mm (3.1 in)
  • Nominal working force: 80 kN (8 tons imp.)
  • Maximum reach: 350 mm (13.8 in)
  • Threading: UN 1˝'' x 16 tpi
  • Weight: 4.6 kg (10 lb)

Puller	Force generator
	Mechanical	TMHP -1	TMHS 5E	TMHS 8E	TMHR 8
	Mechanical  spindle	Hydraulic  spindle	Hydraulic  spindle	Hydraulic  spindle	Hydraulic  ram
TMMA 3	x	-	-	-	-
TMMA 5	x	-	o	-	-
TMMA 5E	-	-	x	-	-
TMMA 8	x	-	-	o	o
TMMA 8E	-	-	-	x	-
TMHP 8	-	x	-	o	o
TMBS 50	x	-	-	-	-
TMBS 100	-	x	-	o	o
TMBS 150	-	x	-	o	o
TMHC 108	-	x	-	o	o

                   x = standard       o = optional      - = not available