Home > All Categories > Electrical Solutions > Multimeters >

TPI-194 CAT IV 600 ACV Data logging True RMS Multimeter
TPI-194 CAT IV 600 ACV Data logging True RMS Digital Multimeter
Our Price: $259.95
Sale Price: $233.96
You save $25.99!

Product Code: TPI-194


0.05% accuracy*, 50,000 count display, CAT IV 600volts, True RMS DMM.

AC/DC volts, AC/DC amps, resistance, audible continuity, diode test, frequency, capacitance, and temperature Plus: db,inductance, conductance, duty cycle, pulse width and time stamp logging.

The Triple Display 194 is an innovative new concept in DMM design. The unique display enables you to view more than one event at a time. This eliminates the hassle of switching back and forth to review minimum, maximum or preset comparative values. The meter is also easy to use and built to last.

The DMM 194 is a hand-held autoranging DMM. The backlit LCD can display three readings at one time. In addition to basic function of AC/DC V, AC/DC A, Ohm, Diode test, continuity, Capacitance, Frequency, there is the adaptor function. The meter also has RS232 output and software for recording information into a PC.


  • Large 50,000 count display increases resolution and improves accuracy (1.7" x 2.75", 43mm x 70mm
  • Triple Display shows more than one reading simultaneously
  • 51 Segment Analog Bar Graph to catch fast AC fluctuations
  • Back Light (LED Type) allows viewing in any light condition
  • Auto Range automatically selects the best range for the measurement
  • Separate battery and fuse compartment for easy replacement
  • True RMS needed to accurately measure nonsinusoidal AC voltage and current waveforms found on controls and circuits
  • Increased safety with Silicone rubber 1,000V CAT III, 600V CAT IV, 10A test leads (CE & cUL listed)
  • Auto Power Off DMM will automatically power down after approximately 15 minutes of inactivity to extend battery life. Disable Auto Power Off: Hold down the REC button and turn the meter on.
  • Diode Test displays approximate forward bias voltage
  • Continuity and buzzer to check for opens and shorts

TPI 194 Specifications

DC Volts Maximum Input: 1000V
Maximum Resolution: 0.0001mV
Accuracy: 0.05%
AC Volts Maximum Input: 1000V
Maximum Resolution: 100V
Accuracy: 0.4%
DC Amps Maximum Input: 10A
Maximum Resolution: 0.01A
Accuracy: 0.15%
AC Amps Maximum Input: 10A
Maximum Resolution: 0.01A
Accuracy: 0.75%
Resistance (Ohms) Maximum Input: 50M
Maximum Resolution: 1m
Accuracy: 0.05%
Frequency Maximum Input: 5MHz
Maximum Resolution: 0.001Hz
Accuracy: 0.05%
Capacitance Maximum Input: 20mF
Maximum Resolution: 0.01nF
Accuracy: 2%
Inductance Maximum Input: 300mH
Maximum Resolution: 0.01mH
Accuracy: 5%

(K-Type Thermocouple)

Maximum Input: -54 to 2462F (-50 to 1350C)
Maximum Resolution: 0.1F/C
Accuracy: 2%
Continuity Audible at less than 10
Diode 3V at 1mA maximum output
Duty Cycle Maximum Input: 99.9%
Maximum Resolution: 0.1%
True RMS Responding Yes
Conductance Yes
Pulse Width Yes
Data Hold Yes (Two hold system)
Min/Max Record Yes
Time Stamp Logging Yes
Relative Mode Yes
Compare Mode Yes
RS-232 Output Yes, Optically Isolated
Process Loop Output No
Sleep Mode / Auto Off Yes
Protective Boot Yes (standard)
Display Type 50,000 count backlit LCD with dual sub displays and analog bargraph
Range Selection Auto/Manual
Operating Temperature 32 to 113F (0 to 40C)
Storage Temperature -4 to 140F (-20 to 60C)
Humidity 80% non-condensing
Size 8.3" x 3.7" x 1.9" (210mm x 95mm x 47mm) without boot
8.7" x 4.3" x 2.6 (220mm x 110mm x 65mm) with boot
Weight 1.3lbs (570g) without boot
1.9lbs (850g) with boot
Battery Type 9V Alkaline (NEDA 1604)
Battery Life 50hrs Typical
OverInput Category CAT IV 600V
Agency Approval cULus 61010-1, IEC 61010-1
Warranty Limited Lifetime

Accessories for this product...
TPI-A192 Software and USB Cable
Our Price: $69.95

TPI-A192 Software and USB Cable

Browse for more products in the same category as this item:

All Categories > Electrical Solutions > Multimeters
Manufacturers > Test Products International